
13
Setting the date
1.Unscrew the crown in the indicat-
ed direction to release it, and pull it
out one step.
2.Set the date by turning the crown.
(If the crown is turned in the wrong
direction there will be no effect.)
3.Push the crown back to its original
position.
4.Hold the crown down and turn it to
screw lock it back in place.
* Setting the date between the
hours of 9 PM and 5 AM may
result in the date not changing by
the next day.
* Do not attempt to set the time or
date when in a mode other than
the Time Mode.
<When manipulating the crown...>
About the screw lock
1.Always return the crown to its original
position and lock it when finished set-
ting the watch.
2.Do not press any of the buttons while
the crown is pulled out. Doing so may
cause a mode change and disturb the
position of the hands.
3.Do not pull out or turn the crown when
it is wet. Doing so may allow water to
seep inside the watch and cause mal-
function.
Time Mode
12
EXIT
24
4
8
12
16
20
.0
.2
.4
.6
.8
DV
10
20
30
40
50
7
C
A
B
E
GF
1
Display in the Time Mode
Please refer to the fold-out watch diagram located
on the opening page of this manual.
A - Points to EXIT
B - Points to 0
C - Minute hand
E - Hour hand
F - Second hand
G - 24-hour time hand
[ Setting the time and date ]
Make sure that the watch is in the Time
Mode by confirming that the function
hand A is pointing to EXIT.
<Setting the time>
1. Unscrew the crown in the indicated
direction to release it, and pull it out two
steps. The second hand F will spin rapid-
ly and stop at 0.
2. Set the hours and minutes by turning
the crown. Check the 24-hour time hand
to confirm whether the hands are set
appropriately to AM or PM.
3. Push the crown back to its original posi-
tion.
4.
Hold the crown down and turn it to screw
lock it back in place.
About the Time Mode
1. The Time Mode displays both 12 and 24-
hour time.
2.
With the exception of the second hand, the time
may be read even while using the other modes.
Screw locked position Freed from the screw
locked position
: Switch to the Time Mode from the Diving Mode by pressing button 1 continuously for 2 sec-
onds. Switch to the Time Mode from the Chronograph Mode by pressing button
1 once.
Komentarze do niniejszej Instrukcji